[PATCH v2 3/4] rust: completion: add complete()

[Maurice Hieronymus]

The initial completion abstraction only added complete_all() and
wait_for_completion(). complete_all() marks the completion permanently
done, which makes a single Completion unsuitable for signalling the same
event repeatedly: once complete_all() has run, every subsequent
wait_for_completion() returns immediately without waiting.

Add complete(), which wakes a single waiter and increments the internal
counter by one. Paired one-to-one with wait_for_completion(), it allows
the same completion to be reused across multiple cycles, e.g. to wait for
consecutive DMA transfers to finish.

Signed-off-by: Maurice Hieronymus <mhi@xxxxxxxxxxx>
---
 rust/kernel/sync/completion.rs | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/rust/kernel/sync/completion.rs b/rust/kernel/sync/completion.rs
index 35ff049ff078..a54361b53644 100644
--- a/rust/kernel/sync/completion.rs
+++ b/rust/kernel/sync/completion.rs
@@ -90,6 +90,17 @@ fn as_raw(&self) -> *mut bindings::completion {
         self.inner.get()
     }
 
+    /// Signal a single task waiting on this completion.
+    ///
+    /// This method wakes up a single task waiting on this completion.
+    /// If no task is currently waiting, the next
+    /// [`Completion::wait_for_completion`] returns immediately.
+    #[inline]
+    pub fn complete(&self) {
+        // SAFETY: `self.as_raw()` is a pointer to a valid `struct completion`.
+        unsafe { bindings::complete(self.as_raw()) };
+    }
+
     /// Signal all tasks waiting on this completion.
     ///
     /// This method wakes up all tasks waiting on this completion; after this operation the

-- 
2.51.2