[PATCH v4 08/19] arm64: dts: qcom: sa8775p: Add minidump SRAM config to SCM node

[Mukesh Ojha]

Point the SCM node at the minidump config slot in the always-on SRAM.
Boot firmware reads this word before DDR is initialised on a warm reset
to decide where to deliver the minidump.

Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>
Signed-off-by: Mukesh Ojha <mukesh.ojha@xxxxxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/lemans.dtsi | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/lemans.dtsi b/arch/arm64/boot/dts/qcom/lemans.dtsi
index 353a6e6fd3ac..a1708bd15076 100644
--- a/arch/arm64/boot/dts/qcom/lemans.dtsi
+++ b/arch/arm64/boot/dts/qcom/lemans.dtsi
@@ -524,6 +524,7 @@ firmware {
 		scm {
 			compatible = "qcom,scm-sa8775p", "qcom,scm";
 			qcom,dload-mode = <&tcsr 0x13000>;
+			sram = <&minidump_config>;
 		};
 	};
 
@@ -6825,6 +6826,10 @@ sram: sram@146d8000 {
 			#address-cells = <1>;
 			#size-cells = <1>;
 
+			minidump_config: minidump-sram@1c {
+				reg = <0x1c 0x4>;
+			};
+
 			pil-reloc@94c {
 				compatible = "qcom,pil-reloc-info";
 				reg = <0x94c 0xc8>;
-- 
2.53.0