Re: [PATCH 5/7] i2c: nomadik: change print level for fault messages to debug

[Linus Walleij]

On Tue, Jun 23, 2026 at 6:32 PM Dmitry Guzman
<Dmitry.Guzman@xxxxxxxxxxxx> wrote:

> i2c-nomadik driver prints error message on every faulted message. This
> is not a good practice, because in I2C a fault not always is an error,
> sometimes it is the expected result. For example, scanning bus with
> `i2cdetects` prints over 100 messages in dmesg (two messages per each
> target address).
>
> To avoid excessive prints in the log, change the print level from err to
> debug.
>
> Signed-off-by: Dmitry Guzman <Dmitry.Guzman@xxxxxxxxxxxx>

Reviewed-by: Linus Walleij <linusw@xxxxxxxxxx>

Yours,
Linus Walleij