Re: [PATCH v2 2/3] arm64: dts: qcom: Add HP EliteBook X G2q 14 AI

[Jason Pettit]

On Fri, 26 Jun 2026 13:27:42 +0200, Konrad Dybcio wrote:
> If you remove these two nodes, the QMPPHY-as-DP-only should still
> function (it's the USB3 block that depends on the QMPPHY, not the
> other way around)

Apologies for the duplicate. My earlier copy of this reply went out with a
misconfigured sender identity from a local mail setup issue. Resending it
cleanly.

I boot-tested this. With &usb_2 and &usb_2_hsphy removed, dmesg still
shows the af64000 DP controller binding and /sys/class/drm shows the
HDMI-A-1 connector as connected, but nothing is displayed on the attached
monitor. With both nodes present, the monitor shows an image.

So removing them stops HDMI from working on this board.
The comment in v3 will be updated to read:

	/* usb_2's combo PHY drives the HDMI bridge over DP; keep the dwc3 enabled. */

Thanks,
Jason