Re: [PATCH v2 2/2] dt-bindings: wireless: ath12k: drop qcom,ath12k-calibration-variant

[Krzysztof Kozlowski]

On 30/06/2026 03:14, Andrew LaMarche wrote:
> The ath12k-wsi binding documentation describes using the
> generation-specific qcom,ath12k-calibration-variant binding as well as
> the generation-agnostic qcom,calibration-variant binding to load
> board-specific calibration data from the device tree. However, the
> driver never implemented either of these.

But DTS did, which I removed. Probably this could be mentioned if it is
relevant.

Anyway:
Please use scripts/get_maintainers.pl to get a list of necessary people
and lists to CC. It might happen, that command when run on an older
kernel, gives you outdated entries. Therefore please be sure you base
your patches on recent Linux kernel.

Tools like b4 or scripts/get_maintainer.pl provide you proper list of
people, so fix your workflow. Tools might also fail if you work on some
ancient tree (don't, instead use mainline) or work on fork of kernel
(don't, instead use mainline). Just use b4 and everything should be
fine, although remember about `b4 prep --auto-to-cc` if you added new
patches to the patchset.

You missed at least devicetree list (maybe more), so this won't be
tested by automated tooling. Performing review on untested code might be
a waste of time.

Please kindly resend and include all necessary To/Cc entries.




Best regards,
Krzysztof