[PATCH 2/2] EDAC/qcom: Skip ECC interrupt setup on Shikra, pre-configured by DSF

[Faiyaz Mohammed]

From: Faiyaz Mohammed <faiyaz.mohammed@xxxxxxxxxxxxxxxx>

On Shikra, the DDR System Firmware (DSF) configures ECC interrupt
routing before the kernel driver probes — it enables Tag/Data RAM
interrupts and programs error thresholds in the LLCC interrupt-enable
registers.

Set irq_configured in shikra_cfg so that qcom_llcc_edac_probe() skips
calling qcom_llcc_core_setup(), which would otherwise overwrite the
firmware-managed register state with redundant writes.

Signed-off-by: Faiyaz Mohammed <faiyaz.mohammed@xxxxxxxxxxxxxxxx>
---
 drivers/soc/qcom/llcc-qcom.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/soc/qcom/llcc-qcom.c b/drivers/soc/qcom/llcc-qcom.c
index 22c8099cf6bb..733999867bbf 100644
--- a/drivers/soc/qcom/llcc-qcom.c
+++ b/drivers/soc/qcom/llcc-qcom.c
@@ -4595,6 +4595,7 @@ static const struct qcom_llcc_config shikra_cfg[] = {
 		.size		= ARRAY_SIZE(shikra_data),
 		.reg_offset	= llcc_v2_1_reg_offset,
 		.edac_reg_offset = &llcc_v2_1_edac_reg_offset,
+		.irq_configured = true,
 	},
 };
 

-- 
2.34.1