Re: [PATCH 0/3] arm64: dts/net: stmmac: Add Agilex5 SoCDK TSN Config2 board support

[Nazle Asmade, Muhammad Nazim Amirul]

On 30/6/2026 9:53 pm, Maxime Chevallier wrote:
> Hi,
> 
> On 6/30/26 15:31, muhammad.nazim.amirul.nazle.asmade@xxxxxxxxxx wrote:
>> From: Nazim Amirul <muhammad.nazim.amirul.nazle.asmade@xxxxxxxxxx>
>>
>> The Intel SoCFPGA Agilex5 SoCDK TSN Config2 board uses a dual-port
>> Ethernet setup where gmac1 (TSN port) operates with different MAC-side
>> and PHY-side interface modes: GMII internally in the MAC, and RGMII
>> towards the PHY.
> 
> There's the same behaviour on Gen5, e.g. CycloneV where we have the
> "EMAC splitter". Based on wether or not we have that splitter in DT,
> we override the INTF_SEL bits to set GMII as the MAC output, the splitter
> converting that to RGMII/SGMII.
> 
> Is there something similar on this AgileX5 version by any chance, for
> which we could reuse the logic ?
> 
> I know that on CycloneV you also need to adjust that GMII -> RGMII/SGMII
> splitter whenever the speed changes, is that different on agileX5 ? have
> you tested 10/100Mbps ?
> 
> Thanks,
> 
> Maxime
Hi Maxime,

Yes, we have tested all three speeds.

10Mbps: Link Up - 10Mbps/Full, throughput ~9.35 Mbits/sec 100Mbps: Link 
Up - 100Mbps/Full, throughput ~94 Mbits/sec 1000Mbps: Link Up - 
1Gbps/Full, throughput ~930 Mbits/sec

BR,
Nazim