Re: [PATCH v3 3/6] firmware: qcom: scm: Add support for setting Bluetooth power modes

[Konrad Dybcio]

On 7/3/26 7:01 AM, George Moussalem via B4 Relay wrote:
> From: George Moussalem <george.moussalem@xxxxxxxxxxx>
> 
> The Bluetooth subsystem (BTSS) on the IPQ5018 SoC supports setting power
> modes which are required to be configured through a Secure Channel
> Manager (SCM) call to TrustZone. However, not all Trusted Execution
> Environment (QSEE) images support this call, so first check if the call
> is available.
> 
> Reviewed-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxxxxxxxx>
> Signed-off-by: George Moussalem <george.moussalem@xxxxxxxxxxx>
> ---

[...]

> @@ -105,6 +105,7 @@ int qcom_scm_shm_bridge_enable(struct device *scm_dev);
>  #define QCOM_SCM_PIL_PAS_SHUTDOWN	0x06
>  #define QCOM_SCM_PIL_PAS_IS_SUPPORTED	0x07
>  #define QCOM_SCM_PIL_PAS_MSS_RESET	0x0a
> +#define QCOM_SCM_PIL_PAS_BT_PWR_MODE	0x21
>  #define QCOM_SCM_PIL_PAS_GET_RSCTABLE	0x21

0_0

collisions here are *bad*.. +cc a couple folks for awareness..

Konrad