Re: [PATCH v2 0/2] firmware: arm_scmi: Ensure automatic module loading

[Sudeep Holla]

On Thu, Jul 09, 2026 at 04:31:00PM +0200, Hans de Goede wrote:
> Hi,
> 
> On 9-Jul-26 16:21, Sudeep Holla wrote:
[...]
> > 
> > I need to recall why we moved from static list of devices to dynamic.
> > One reason I can think right now is the vendor protocols and their drivers
> > But in general it was an attempt to help multiple drivers bind to different
> > scmi_devices that have same protocol ID. E.g. the performance protocol
> > can be used by cpufreq and devfreq/performance genpd drivers.
> 
> Note it is ok to have multiple drivers bind to the same modalias,
> depending on the reason why there are multiple drivers either one
> should detect that it is not compatible and exit probe() with -ENODEV
> or there should be some other mechanism to make sure only one driver
> loads.
> 
> E.g. duplicate USB device-ids happen (they shouldn't but they do) and
> then the drivers typically figure out if they are talking to the device
> which they were written for, or the other device with the same USB-ids
> and then one of the 2 drivers exits with -ENODEV.
> 

Understood. Sorry I tried to explain with examples assuming you may not
be aware of the details, but now reading your response, you have better
examples.

> >> I wonder if we can just move a small part of the drivers
> >> (some mapping table) into the bus code and then just have this work as it
> >> does on regular busses. I hope to be able to make some time to look into
> >> this soonish.
> >>
> > 
> > I started with that few years ago and we then moved to this dynamic
> > device creation. But I agree if it is deviation from the norms(which I
> > wasn't aware of at the time), we can remove it.
> 
> Looking at the issue this is causing for automatic module loading if we
> can get back to the bus enumeration code always creating a device without
> waiting for the driver kmod to load then that would be good IMHO.
> 

Sure if it fixes the issue for you. Cristian can point out anything I
might have missed to consider as he is the one who reworked it and made
it dynamic device creation which at the time sounded nice option to
solve the issue. We weren't aware that it could cause such issues 🙁.

-- 
Regards,
Sudeep