Re: [PATCH 2/3] arm64: dts: qcom: ipq5424-rdp466: Enable quad SPI mode for SPI-NAND

[Konrad Dybcio]

On 7/16/26 7:55 AM, Md Sadre Alam wrote:
> Enable quad SPI transfers for the SPI-NAND device by setting both spi-rx-
> bus-width and spi-tx-bus-width to 4.
> 
> Without these properties, the device uses the default single-bit bus width.
> Configure the board to use 4-bit read and write transfers so the controller
> and flash can operate in quad SPI mode.
> 
> Signed-off-by: Md Sadre Alam <md.alam@xxxxxxxxxxxxxxxx>
> ---

Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>

Konrad