Re: [PATCH v3 phy-next 8/8] phy: lynx-10g: use RCW override procedure for dynamic protocol change

Next message: Shrikanth Hegde: "[PATCH v8 05/11] sched/fair: Load balance only among preferred CPUs"
Previous message: Shrikanth Hegde: "[PATCH v8 04/11] sched/core: Try to use a preferred CPU in is_cpu_allowed"
In reply to: Vladimir Oltean: "[PATCH v3 phy-next 8/8] phy: lynx-10g: use RCW override procedure for dynamic protocol change"
Next in thread: Vladimir Oltean: "Re: [PATCH v3 phy-next 8/8] phy: lynx-10g: use RCW override procedure for dynamic protocol change"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

From: Vinod Koul

Date: Mon Jul 20 2026 - 13:29:15 EST

On 20-07-26, 16:36, Vladimir Oltean wrote:
> Up until this patch, the only protocol change supported was between
> 1000Base-X/SGMII and 2500Base-X. The others require an RCW override
> procedure which was lacking.
>
> Since now the guts driver provides the means of applying this procedure,
> make use of it and remove any comment which mentioned the limitation.

lgtm, is there any dependency. If not I can pick it

--
~Vinod