Re: [PATCH v2 4/4] arm64: dts: qcom: shikra: Add support for AudioCoreCC and AudioCoreCSR nodes

[Imran Shaik]

On 22-07-2026 11:54 am, Dmitry Baryshkov wrote:
> On Mon, Jul 13, 2026 at 06:01:34PM +0530, Imran Shaik wrote:
> > On 13-07-2026 05:44 pm, Konrad Dybcio wrote:
> > > On 7/13/26 2:07 PM, Imran Shaik wrote:
> > > > On 09-07-2026 05:30 pm, Konrad Dybcio wrote:
> > > > > On 7/8/26 8:25 PM, Imran Shaik wrote:
> > > > > > Add support for Audio Core Clock Controller (AudioCoreCC) and Audio Core
> > > > > > CSR nodes on Qualcomm Shikra SoC. The Audio Core Clocks and Resets support
> > > > > > differs across Shikra variants based on Audio subsystem enablement as
> > > > > > follows:
> > > > > > - CQM variant: The QAIF driver runs on HLOS, hence both clocks and resets
> > > > > > are required to be supported on HLOS.
> > > > > > - CQS variant: The QAIF driver runs on the Modem, and required clocks are
> > > > > > handled on Modem, so from HLOS only resets are needed.
> > > > > > - IQS variant: no soundwire codes, hence no clocks/resets are needed.
> > > > > >
> > > > > > Signed-off-by: Imran Shaik <imran.shaik@xxxxxxxxxxxxxxxx>
> > > > > > ---
> > > > >
> > > > > For the sake of simplification, can the resets be enabled
> > > > > globally by default?
> > > >
> > > > By default (PoR), those resets are under HW control. For audio use cases, software desserts/asserts for switching to SW control. Hence, these cannot be enabled globally by default.
> > >
> > > What does enabling the provider node have to do with changing the
> > > state of the resources?
> >
> > My bad, I interpreted it in wrong way.
> >
> > We have IQS variant, where we don't have the soundwire codes, and hence the
> > respective clocks/resets are not required to be supported. Due to this, I
> > have kept the status disabled, and enabling only where it is required.
>
> Would it make sense to do it differently - disable them for the IQS?

Yeah, we can keep the audiocore_csr node enabled by default and disable
it in the IQS variant.

But Konrad suggested to keep it globally enabled and not disable in IQS 
variant for simplification since no one will consume those resets in the 
IQS variant and no functional impact.

Please suggest which approach to follow here.

> Is SoundWire not supported on the IQS at all or is it not a part of the
> EVK?

As per my discussion with the Audio team, the IQS EVK board has no 
soundwire based audio codec connected. Actually, in the IQS hardware the 
AudioCoreCSR registers are present, but based on the Audio requirements 
we are not supporting it in IQS variant.

Thanks,
Imran

> > > FWIW there's nothing like reset_sync_state
> >
> > Sure, I can keep the audiocore_csr node enabled by default.
> >
> > > Konrad