[PATCH] phy: broadcom: ns2-usbdrd: cancel delayed work

[Hongyan Xu]

ns2_drd_phy_probe() initializes wq_extcon. Both GPIO IRQs and the probe
tail can queue it. There is no remove hook, so the delayed work can run
after driver-managed resources are being released.

Add a managed cleanup action before requesting IRQs. Devres releases the
IRQs first, then cancels the delayed work while extcon, GPIO and MMIO
state is still valid.

This issue was found by a static analysis tool.

Signed-off-by: Hongyan Xu <getshell@xxxxxxxxxx>
---
 drivers/phy/broadcom/phy-bcm-ns2-usbdrd.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/drivers/phy/broadcom/phy-bcm-ns2-usbdrd.c b/drivers/phy/broadcom/phy-bcm-ns2-usbdrd.c
index 36ad02c33..54929edb1 100644
--- a/drivers/phy/broadcom/phy-bcm-ns2-usbdrd.c
+++ b/drivers/phy/broadcom/phy-bcm-ns2-usbdrd.c
@@ -264,6 +264,13 @@ static irqreturn_t gpio_irq_handler(int irq, void *dev_id)
 	return IRQ_HANDLED;
 }
 
+static void ns2_drd_phy_cancel_work(void *data)
+{
+	struct ns2_phy_driver *driver = data;
+
+	cancel_delayed_work_sync(&driver->wq_extcon);
+}
+
 static const struct phy_ops ops = {
 	.init		= ns2_drd_phy_init,
 	.power_on	= ns2_drd_phy_poweron,
@@ -342,6 +349,10 @@ static int ns2_drd_phy_probe(struct platform_device *pdev)
 
 	INIT_DELAYED_WORK(&driver->wq_extcon, extcon_work);
 
+	ret = devm_add_action_or_reset(dev, ns2_drd_phy_cancel_work, driver);
+	if (ret)
+		return ret;
+
 	driver->id_irq = gpiod_to_irq(driver->id_gpiod);
 	if (driver->id_irq < 0) {
 		dev_err(dev, "failed to get ID IRQ\n");
-- 
2.50.1.windows.1