Re: [PATCH v2 4/4] riscv: dts: spacemit: Add Milk-V Jupiter board (M1)

[Aurelien Jarno]

Hi Yixun,

On 2026-07-30 08:54, Yixun Lan wrote:
> Hi Aurelien, 
> 
> 
> On 18:00 Wed 29 Jul     , Aurelien Jarno wrote:
> > Add support for the Milk-V Jupiter board with the M1 CPU. The M1 differs
> > from the K1 only by its package, which provides improved cooling
> > performance and allows it to run at up to 1.8 GHz instead of 1.6 GHz.
> > 
> > Add m1-opp.dtsi to define the 1.8 GHz operating point and the
> > corresponding core voltage, based on the upstream kernel. Include it
> > from m1-milkv-jupiter.dts. Raise the maximum buck1 voltage to 1.116V to
> > match the new operating point.
> > 
> While checking the schematics, the buck1,2 provide power supply both
> for cpu core and AVDD09 domain - check schematics page 9/25 [1]
> 
> the R81 is NC, so buck1,2 is actually all power supply, raise voltage will
> result high risk to damage the chip (overvoltage of AVDD09 domain), so

Yes, both buck1 and buck2 supply the CPU core. I only raised buck1 here, 
because it's the only one controlled by the cpu scaling, but in practice 
I believe that configuring the PMIC as Dual-Phase Mode couple the two 
regulator at the hardware level and only the first one need to be set. 
See my analysis there:
https://lore.kernel.org/spacemit/178402025712.1568061.9223355686030414906.b4-ty@b4/T/#m828e80aaf454606baafbd43e3795089ba397145f

But I can indeed raise both values for consistency.

> a safe strategy would to test if M1 able to run at 1.8G without voltage 
> change (still at 1.05v)?

I'll try that, but my guess is that given the vendor kernel raises the 
voltage to 1.116V, it is actually needed.

Regards
Aurelien

-- 
Aurelien Jarno                          GPG: 4096R/1DDD8C9B
aurelien@xxxxxxxxxxx                     http://aurel32.net