Re: [GIT PULL] thermal drivers for v7.3-rc1

[Rafael J. Wysocki (Intel)]

Hi Daniel,

On Fri, Aug 7, 2026 at 10:04 PM Daniel Lezcano
<daniel.lezcano@xxxxxxxxxxxxxxxx> wrote:
>
>
> Hi Rafael,
>
> please consider the following changes since commit
> 8cdeaa50eae8dad34885515f62559ee83e7e8dda:
>
>    Linux 7.2-rc2 (2026-07-05 14:44:06 -1000)
>
> are available in the Git repository at:
>
>
> ssh://git@xxxxxxxxxxxxxxxxxxx/pub/scm/linux/kernel/git/thermal/linux.git
> tags/thermal-v7.3-rc1
>
> for you to fetch changes up to 55c16e15ff9f91bc994a20124b83faf27f0e3690:
>
>    thermal/drivers: Remove redundant error messages on IRQ request
> failure (2026-08-07 17:27:28 +0200)
>
> ----------------------------------------------------------------
> - Move thermal_zone_device_enable() to the right place in order to
>    prevent calling it if the thermal zone registration failed (Dan
>    Carpenter)
>
> - Improve bitfield manipulations on Armada (Bryan B. Lima)
>
> - Remove unneeded 'fast_io' on Sun8i and Armada (Wolfram Sang)
>
> - Fix wrong boundary when clamping the low values in the set_trips()
>    callback and fix wrong mask when setting the temperature interval on
>    Airoha (Christian Marangi)
>
> - Make use of the regmap API in order to support the Airoha AN7583
>    (Christian Marangi)
>
> - Fix adc_tm5_get_temp() return check value on the QCom SPMI ADC
>    sensor (Rakesh Kota)
>
> - Fix unbalanced clock enablement when the resume fails on the iMX
>    driver (Can Peng)
>
> - Add Qualcomm Master BandGap thermal monitor support (Satya Priya
>    Kakitapalli)
>
> - Add Maili Temperature bindings compatible (Haritha S K)
>
> - Add a devm action to clean hardware interrupts, sampling, and
>    control registers on Spacemit K1 (Pei Xiao)
>
> - Fix trivial typo in an OF code comment (Marek Vasut)
>
> - Remove unecessary print on Qcom SPMI ADC driver when a call to
>    devm_request_threaded_irq() fails as this one already prints a
>    message (Jishnu Prakash)
>
> - Add support for QCom PMIC5 Gen3 ADC by using auxialiary driver and
>    shared interrupt with the IIO driver (Jishnu Prakash)
>
> - Make resets optional on MT8196 and add the corresponding property in
>    the DT bindings (AngeloGioacchino Del Regno)
>
> - Fix clock staying enabled with the resume operation fails on Qoriq
>    (Can Peng)
>
> - Fix wrong closing brace position in thermal library header (Andreas
>    Haufler)
>
> - Fix low and high trip point validation by moving the check after the
>    clamp on the spacemit driver (surendra)
>
> - Remove redundant error messages on IRQ request failure (Pan Chuang)
>

Pulled and added to linux-pm/thermal, thanks!