[PATCH v2 0/2] spi: qcom-geni: Use GPIO to notify master of SPI target activity

[Praveen Talari]

When operating in SPI target mode, the GENI controller relies on an
external GPIO to notify the SPI master about the target's active state.

Add support for an optional device GPIO that is asserted when a target
transfer begins and deasserted when the transfer completes, is aborted,
or hits a timeout. This allows the target to explicitly signal its
availability to the master and ensures the GPIO is released in all error
and completion paths, preventing the master from observing a stale or
incorrect target ready indication.

The ready GPIO is intentionally made optional and is requested only
when target mode is enabled. This preserves existing behaviour for
systems that do not require the signal and avoids regressions on
deployed platforms where the GPIO is already controlled from userspace.
Targets without a ready GPIO continue to operate unchanged by using
devm_gpiod_get_index_optional().

Signed-off-by: Praveen Talari <praveen.talari@xxxxxxxxxxxxxxxx>
---
Changes in v2:
- Used ready-gpio instead of target-gpio.
- Updated commit text.
- Link to v1: https://patch.msgid.link/20260806-use_gpio_to_notify_master_of_spi_target_activity-v1-0-c363a9b5df69@xxxxxxxxxxxxxxxx

---
Praveen Talari (2):
      dt-bindings: spi: qcom-geni: Document ready-gpios property
      spi: qcom-geni: Use GPIO to notify master of SPI target activity

 .../bindings/spi/qcom,sa8255p-geni-spi.yaml        |  9 ++++++++
 .../bindings/spi/qcom,spi-geni-qcom.yaml           |  9 ++++++++
 drivers/spi/spi-geni-qcom.c                        | 25 ++++++++++++++++++++--
 3 files changed, 41 insertions(+), 2 deletions(-)
---
base-commit: 78bc8af4affb9a732504eb22eeac7d1e50883853
change-id: 20260729-use_gpio_to_notify_master_of_spi_target_activity-5f62a9e14875

Best regards,
--  
Praveen Talari <praveen.talari@xxxxxxxxxxxxxxxx>