Re: [PATCH v3 2/2] arm64: dts: qcom: qcs6490-rubikpi3: Add IMX219 camera overlays

[Konrad Dybcio]

On 8/12/26 4:22 AM, Hongyang Zhao wrote:
> RUBIK Pi 3 ships without camera sensors, and its two connectors support
> multiple modules. Keep module-specific nodes out of the base board DTS
> and add per-connector overlays for Raspberry Pi Camera Module V2 IMX219
> sensors.
> 
> CAM1 uses CCI1 and CSIPHY1, while CAM2 uses CCI0 and CSIPHY4. Each
> overlay describes the 24 MHz sensor input clock and models the module
> power domain controlled through the connector PWR_EN signal. The
> baseboard supplies VCC3V3_OUTPUT separately and has no per-camera
> regulator.
> 
> Describe each connector CAMERA_GPIO signal as a privacy indicator LED
> and associate it with the corresponding sensor. This lets the V4L2 core
> control the LED while the sensor is streaming.
> 
> Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
> Signed-off-by: Hongyang Zhao <hongyang.zhao@xxxxxxxxxxxxxxx>
> ---

[...]

> +	camera@10 {
> +		compatible = "sony,imx219";
> +		reg = <0x10>;
> +
> +		clocks = <&cam1_imx219_clk>;
> +
> +		VANA-supply = <&vreg_cam1_pwr>;
> +		VDIG-supply = <&vreg_cam1_pwr>;
> +		VDDL-supply = <&vreg_cam1_pwr>;
> +
> +		leds = <&cam1_privacy_led>;
> +		led-names = "privacy";

No reset GPIOs?

You should also have a reference to the mclk pin state to make sure
the correct pin function kicks in

Konrad