[PATCH 4/4] phy: qcom: qmp-combo: Add USB3+DP PHY support for Nord

[Shawn Guo]

From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxxxxxxxx>

Nord SoC provides two USB3+DP combo PHYs. Their initialisation sequences
are identical to sm8550, but the sub-blocks are not laid out the same way:
Nord adds a dedicated USB3_PCS_AON region at offset 0x1e00 and leaves
everything else where sm8550 has it. None of the existing offsets tables
describe that, so add a v6 table which is the v3 layout plus usb3_pcs_aon.

Populating usb3_pcs_aon changes where the driver drives the I/O clamp when
entering and leaving autonomous mode: it now uses the real AON region
rather than falling back to PCS_MISC, which is what platforms with no AON
region do.

The offsets were confirmed against the Nord register map for both PHY
instances, USB3_DP_PHY_0 at 0x088e1000 and USB3_DP_PHY_1 at 0x088e4000.
USB3_PCS_AON_CLAMP_ENABLE sits at offset 0x00 of the AON region with a
single CLAMP_EN_B bit, matching QPHY_V6_PCS_AON_CLAMP_ENABLE and CLAMP_EN.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxxxxxxxx>
Assisted-by: LLM
Signed-off-by: Shawn Guo <shengchao.guo@xxxxxxxxxxxxxxxx>
---
 drivers/phy/qualcomm/phy-qcom-qmp-combo.c | 66 +++++++++++++++++++++++
 1 file changed, 66 insertions(+)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-combo.c b/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
index c39ced168d03..de82c7107c92 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
@@ -2690,6 +2690,23 @@ static const struct qmp_combo_offsets qmp_combo_offsets_v5 = {
 	.dp_dp_phy	= 0x2200,
 };
 
+static const struct qmp_combo_offsets qmp_combo_offsets_v6 = {
+	.com		= 0x0000,
+	.txa		= 0x1200,
+	.rxa		= 0x1400,
+	.txb		= 0x1600,
+	.rxb		= 0x1800,
+	.usb3_serdes	= 0x1000,
+	.usb3_pcs_misc	= 0x1a00,
+	.usb3_pcs	= 0x1c00,
+	.usb3_pcs_aon	= 0x1e00,
+	.usb3_pcs_usb	= 0x1f00,
+	.dp_serdes	= 0x2000,
+	.dp_txa		= 0x2200,
+	.dp_txb		= 0x2600,
+	.dp_dp_phy	= 0x2a00,
+};
+
 static const struct qmp_combo_offsets qmp_combo_offsets_v8 = {
 	.com		= 0x0000,
 	.txa		= 0x1400,
@@ -3394,6 +3411,51 @@ static const struct qmp_phy_cfg glymur_usb3dpphy_cfg = {
 	.num_vregs		= ARRAY_SIZE(qmp_phy_vreg_refgen),
 };
 
+static const struct qmp_phy_cfg nord_usb3dpphy_cfg = {
+	.offsets		= &qmp_combo_offsets_v6,
+
+	.serdes_tbl		= sm8550_usb3_serdes_tbl,
+	.serdes_tbl_num		= ARRAY_SIZE(sm8550_usb3_serdes_tbl),
+	.tx_tbl			= sm8550_usb3_tx_tbl,
+	.tx_tbl_num		= ARRAY_SIZE(sm8550_usb3_tx_tbl),
+	.rx_tbl			= sm8550_usb3_rx_tbl,
+	.rx_tbl_num		= ARRAY_SIZE(sm8550_usb3_rx_tbl),
+	.pcs_tbl		= sm8550_usb3_pcs_tbl,
+	.pcs_tbl_num		= ARRAY_SIZE(sm8550_usb3_pcs_tbl),
+	.pcs_usb_tbl		= sm8550_usb3_pcs_usb_tbl,
+	.pcs_usb_tbl_num	= ARRAY_SIZE(sm8550_usb3_pcs_usb_tbl),
+
+	.dp_serdes_tbl		= qmp_v6_dp_serdes_tbl,
+	.dp_serdes_tbl_num	= ARRAY_SIZE(qmp_v6_dp_serdes_tbl),
+	.dp_tx_tbl		= qmp_v6_dp_tx_tbl,
+	.dp_tx_tbl_num		= ARRAY_SIZE(qmp_v6_dp_tx_tbl),
+
+	.serdes_tbl_rbr		= qmp_v6_dp_serdes_tbl_rbr,
+	.serdes_tbl_rbr_num	= ARRAY_SIZE(qmp_v6_dp_serdes_tbl_rbr),
+	.serdes_tbl_hbr		= qmp_v6_dp_serdes_tbl_hbr,
+	.serdes_tbl_hbr_num	= ARRAY_SIZE(qmp_v6_dp_serdes_tbl_hbr),
+	.serdes_tbl_hbr2	= qmp_v6_dp_serdes_tbl_hbr2,
+	.serdes_tbl_hbr2_num	= ARRAY_SIZE(qmp_v6_dp_serdes_tbl_hbr2),
+	.serdes_tbl_hbr3	= qmp_v6_dp_serdes_tbl_hbr3,
+	.serdes_tbl_hbr3_num	= ARRAY_SIZE(qmp_v6_dp_serdes_tbl_hbr3),
+
+	.swing_hbr_rbr		= &qmp_dp_v5_voltage_swing_hbr_rbr,
+	.pre_emphasis_hbr_rbr	= &qmp_dp_v6_pre_emphasis_hbr_rbr,
+	.swing_hbr3_hbr2	= &qmp_dp_v5_voltage_swing_hbr3_hbr2,
+	.pre_emphasis_hbr3_hbr2	= &qmp_dp_v5_pre_emphasis_hbr3_hbr2,
+
+	.dp_aux_init		= qmp_v4_dp_aux_init,
+	.configure_dp_tx	= qmp_v4_configure_dp_tx,
+	.configure_dp_clocks	= qmp_v3_configure_dp_clocks,
+	.configure_dp_phy	= qmp_v4_configure_dp_phy,
+
+	.regs			= qmp_v6_usb3phy_regs_layout,
+	.reset_list		= msm8996_usb3phy_reset_l,
+	.num_resets		= ARRAY_SIZE(msm8996_usb3phy_reset_l),
+	.vreg_list		= qmp_phy_vreg_l,
+	.num_vregs		= ARRAY_SIZE(qmp_phy_vreg_l),
+};
+
 static int qmp_combo_dp_serdes_init(struct qmp_combo *qmp)
 {
 	const struct qmp_phy_cfg *cfg = qmp->cfg;
@@ -5359,6 +5421,10 @@ static const struct of_device_id qmp_combo_of_match_table[] = {
 		.compatible = "qcom,hawi-qmp-usb3-dp-phy",
 		.data = &hawi_usb3dpphy_cfg,
 	},
+	{
+		.compatible = "qcom,nord-qmp-usb3-dp-phy",
+		.data = &nord_usb3dpphy_cfg,
+	},
 	{
 		.compatible = "qcom,sar2130p-qmp-usb3-dp-phy",
 		.data = &sar2130p_usb3dpphy_cfg,
-- 
2.43.0