Re: [PATCH] drm/msm/dsi: round the byte clock rate after reparenting to the PHY PLL

[Abel Vesa]

On 26-09-03 15:19:10, Dmitry Baryshkov wrote:
> DSI 6G v2.9 hosts (SM8650, SM8750, Kaanapali, etc.) reparent the byte and
> pixel RCGs to the DSI PHY PLL at runtime from
> dsi_link_clk_set_rate_6g_v2_9(), after the PHY has been enabled. However
> dsi_calc_clk_rate_6g() runs earlier, in order to compute the bit clock
> request for the PHY. At that point the byte RCG still has its reset
> parent (XO), so clk_round_rate() returns a bogus rate, which then ends up
> in the PHY bit clock request and the PLL gets programmed to a wrong
> frequency, breaking the panel.
> 
> Move the rounding to dsi_link_clk_set_rate_6g(), which is called after
> the RCGs have been reparented to the PLL. Storing the rounded rate at
> this point still makes later link_clk_set_rate() calls no-ops in the
> CCF. Derive the byte interface clock rate from the rounded byte clock
> rate, otherwise it would keep requesting the idealized rate and
> retrigger the PLL on every transfer.
> 
> Reported-by: Abel Vesa <abel.vesa@xxxxxxxxxxxxxxxx>
> Reported-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxxxxx>
> Fixes: 6cd33b6f4155 ("drm/msm/dsi: round 6G byte clock rate to the PLL-achievable value")
> Assisted-by: LLM
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxxxxxxxx>

Tested on Eliza MTP.

Tested-by: Abel Vesa <abel.vesa@xxxxxxxxxxxxxxxx>
Reviewed-by: Abel Vesa <abel.vesa@xxxxxxxxxxxxxxxx>