Re: [PATCH] docs: misc-devices/spear-pcie-gadget.txt: Fix bracket and whitespace

[Randy Dunlap]

On 9/5/26 12:46 AM, Manuel Ebner wrote:
> Add missing ')' and remove needless whitespace.
> 
> Signed-off-by: Manuel Ebner <manuelebnerli@xxxxxxxxxxx>

Whitespace patches usually fall into my (personal) category of
not worth the hassle or time. Anyway:

Reviewed-by: Randy Dunlap <rdunlap@xxxxxxxxxxxxx>

Oh, there are 3 places where "MSI vector" should be "MSI vectors".

> ---
>  Documentation/misc-devices/spear-pcie-gadget.rst | 10 +++++-----
>  1 file changed, 5 insertions(+), 5 deletions(-)
> 
> diff --git a/Documentation/misc-devices/spear-pcie-gadget.rst b/Documentation/misc-devices/spear-pcie-gadget.rst
> index 09b9d6c7a..13333a209 100644
> --- a/Documentation/misc-devices/spear-pcie-gadget.rst
> +++ b/Documentation/misc-devices/spear-pcie-gadget.rst
> @@ -37,9 +37,9 @@ read behavior of nodes:
>  -----------------------
>  
>  =============== ==============================================================
> -link 		gives ltssm status.
> -int_type 	type of supported interrupt
> -no_of_msi 	zero if MSI is not enabled by host. A positive value is the
> +link		gives ltssm status.
> +int_type	type of supported interrupt
> +no_of_msi	zero if MSI is not enabled by host. A positive value is the
>  		number of MSI vector granted.
>  vendor_id	returns programmed vendor id (hex)
>  device_id	returns programmed device id(hex)
> @@ -53,7 +53,7 @@ write behavior of nodes:
>  ------------------------
>  
>  =============== ================================================================
> -link 		write UP to enable ltsmm DOWN to disable
> +link		write UP to enable ltsmm DOWN to disable
>  int_type	write interrupt type to be configured and (int_type could be
>  		INTA, MSI or NO_INT). Select MSI only when you have programmed
>  		no_of_msi node.
> @@ -65,7 +65,7 @@ device_id	write device id(hex) to be programmed.
>  bar0_size	write size of bar0 in hex. default bar0 size is 1000 (hex)
>  		bytes.
>  bar0_address	write	address of bar0 mapped area in hex. (default mapping of
> -		bar0 is SYSRAM1(E0800000). Always program bar size before bar
> +		bar0 is SYSRAM1(E0800000)). Always program bar size before bar
>  		address. Kernel might modify bar size and address for alignment,
>  		so read back bar size and address after writing to cross check.
>  bar0_rw_offset	write offset of bar0 for which	bar0_data will write value.

thanks.
-- 
~Randy