Re: [PATCH v6 00/11] arm64: dts: monaco-arduino-monza: Add support for LGA WiFi/BT module

[Loic Poulain]

Hi Bartosz,

On Mon, Sep 7, 2026 at 10:24 AM Bartosz Golaszewski <brgl@xxxxxxxxxx> wrote:
>
> On Fri, 4 Sep 2026 17:42:15 +0200, Loic Poulain
> <loic.poulain@xxxxxxxxxxxxxxxx> said:
> > This series describes support for the onboard WiFi/Bluetooth module
> > present on the Arduino VENTUNO Q (monaco) platform.
> >
> > The board provides LGA pads for a wireless module. On the VENTUNO Q
> > these pads are populated with an NFA725B module featuring the
> > QCA2066 WiFi/BT combo chip. While implemented as an LGA footprint,
> > the design is functionally compatible with the M.2 Key E.
> >
> > The NFA725B exposes WiFi over PCIe and Bluetooth over a UART.
> > Both interfaces are gated through the W_DISABLE1# and W_DISABLE2#
> > signals, as defined by the M.2 specification and handled here via
> > the pcie-m2 power sequencer.
> >
> > This series models the hardware using the existing pwrseq framework
> > and connector bindings, allowing coordinated PCIe and UART bring-up.
> >
> > Signed-off-by: Loic Poulain <loic.poulain@xxxxxxxxxxxxxxxx>
> > ---
>
> What is the merge strategy? Do the pwrseq changes depend on first two bluetooth
> patches (I don't think so)? Can they go onto an immutable branch shared with
> the BT tree?

The pwrseq changes are only a dependency for the Bluetooth changes,
not the other way around. So yes, they can potentially go separately.

Regards,
Loic