Re: [PATCH v3 00/10] Support ROHM BD73800

[Lee Jones]

On Fri, 11 Sep 2026, Matti Vaittinen wrote:

> On 10/09/2026 19:03, Lee Jones wrote:
> > On Wed, 02 Sep 2026, Matti Vaittinen wrote:
> > 
> > > Add support for the ROHM BD73800 PMIC and compatibles.
> > > 
> > > The ROHM BD73800 is a power management IC which integrates 8 BUCKs and 4
> > > LDOs. There is also an ADC and operation amplifier intended for current
> > > / temperature measurement and accumulation. RTC and 32.768 kHz clock
> > > gate are also included. The PMIC can be customized via OTP and it has
> > > options for operating as a main PMIC in multi-PMIC installation. Some
> > > of the pins can also be used for GPO or GPI (including interrupt support).
> > > 
> > > There are also ROHM BD71851 and BD71885 PMICs out there. These are, from
> > > the SW-perspective, similar to the BD73800. There is only some different
> > > default values and OTP settings. The driver should be able to handle them
> > > just fine.
> > > 
> > > Revision history:
> > > 
> > > v2 => v3:
> > >   - Rebased on v7.3-rc1.
> > >   - gpio: Use gpio-regmap as was suggested by Linus W.
> > >   More accurate change-log in individual patches.
> > > 
> > > v1 => v2:
> > >   - Rebased on regulator/for-7.3 as it carries dependency:
> > >     f29a8bf6fde1 ("regulator: dt-bindings: ROHM PMIC state-machine voltages")
> > >   - dt-bindings: Various fixes, split generic stuff to own files.
> > >   - gpio: Styling, return -ENODEV if no GPIOs found
> > >   - MFD: Styling
> > >   - regulator: Simplify dt-reading
> > >   More accurate change-log in individual patches.
> > 
> > I assume there will be one more revision?
> > 
> 
> Hi Lee,
> 
> I thought everything was acked and good to go?

I just saw the nits and commented before the blessing.

However, you may as well fix them and submit.  I'll apply the set when you do.

-- 
Lee Jones