Re: [PATCH v2] arm64: dts: qcom: monaco-arduino-monza: Rework fan cooling map

[Bjorn Andersson]

On Mon, 03 Aug 2026 13:55:57 +0200, Loic Poulain wrote:
> The fan thermal zone previously had a single "active" trip at 32C mapped
> to the fan over the full cooling range (<&fan 0 THERMAL_NO_LIMIT>). With
> the default step_wise governor this only ramps the fan one step per poll
> according to the thermal trend, so the fan speed tracked whether the
> temperature was rising or falling rather than the temperature itself.
> 
> A visible consequence is at boot/reboot: if the board comes up already
> hot but thermally stable (temperature above the trip but not rising),
> step_wise sees no upward trend and leaves the fan at a low or zero
> cooling state, so the fan stays slow despite the high temperature.
> 
> [...]

Applied, thanks!

[1/1] arm64: dts: qcom: monaco-arduino-monza: Rework fan cooling map
      commit: 4e7a6ce7925c463f9e888c87a1a40e68db8a32a9

Best regards,
-- 
Bjorn Andersson <andersson@xxxxxxxxxx>