Re: [PATCH v3 07/12] arm64: dts: qcom: pm8350c: Enable BCL sensor node

[Abel Vesa]

On 26-09-29 18:39:39, Manaf Meethalavalappu Pallikunhi wrote:
> Add Battery Current Limiting (BCL) hardware monitor node for pm8350c
> PMIC. The BCL monitors battery voltage and current, providing hardware
> interrupts when configurable thresholds are violated.
> 
> Signed-off-by: Manaf Meethalavalappu Pallikunhi <manaf.pallikunhi@xxxxxxxxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/pm8350c.dtsi | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
> index 1a24e6439e36..52b5fc1ef9a3 100644
> --- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
> +++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
> @@ -20,6 +20,17 @@ pm8350c_temp_alarm: temp-alarm@a00 {
>  			#thermal-sensor-cells = <0>;
>  		};
>  
> +		sensor@4700 {
> +			compatible = "qcom,pm8350c-bcl";
> +			reg = <0x4700>;
> +			interrupts = <0x2 0x47 0x0 IRQ_TYPE_EDGE_RISING>,
> +				     <0x2 0x47 0x1 IRQ_TYPE_EDGE_RISING>,
> +				     <0x2 0x47 0x2 IRQ_TYPE_EDGE_RISING>;
> +			interrupt-names = "max-min",
> +					  "critical",
> +					  "emergency";
> +		};
> +
>  		pm8350c_gpios: gpio@8800 {
>  			compatible = "qcom,pm8350c-gpio", "qcom,spmi-gpio";
>  			reg = <0x8800>;
> @@ -41,6 +52,7 @@ pm8350c_pwm: pwm {
>  			#pwm-cells = <2>;
>  			status = "disabled";
>  		};
> +

Drop this new empty line.

>  	};
>  };
>  
> 
> -- 
> 2.43.0
>