Re: [PATCH] irqchip/meson-gpio: Allow the GPIO interrupts to wake the system

[Neil Armstrong]

On 10/7/26 23:55, Igor Velkov via B4 Relay wrote:
> From: Igor Velkov <iav@xxxxxx>
>
> meson_gpio_irq_chip has neither .irq_set_wake nor IRQCHIP_SKIP_SET_WAKE,
> so enable_irq_wake() fails with -ENXIO for every interrupt routed through
> it. Such an interrupt cannot wake the system from suspend.
>
> Set IRQCHIP_SKIP_SET_WAKE, like the other hierarchical irqchips with a
> GIC parent. The GIC sets the same flag, so irq_chip_set_wake_parent()
> would end there anyway.
>
> Tested on ODROID-HC4 with the PCF8563 alarm interrupt routed through this
> controller: the alarm wakes the board from s2idle 4/4, and 0/1 without
> this change.

The code sound valid but the this paragraph means nothing, adding or removing
IRQCHIP_SKIP_SET_WAKE should not change the fact PCF8563 would wake up the ODROID-HC4
since the BL301 firmware hardcodes which gpio can wakeup.

I guess this flag simply removes an error when setting the gpio as wakeup source
which means nothing in this platform anyway. So please rephrase.

Neil

> Assisted-by: LLM
> Signed-off-by: Igor Velkov <iav@xxxxxx>
> ---
>   drivers/irqchip/irq-meson-gpio.c | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/irqchip/irq-meson-gpio.c b/drivers/irqchip/irq-meson-gpio.c
> index 91a9c337fe6d..e0329ef5e4a2 100644
> --- a/drivers/irqchip/irq-meson-gpio.c
> +++ b/drivers/irqchip/irq-meson-gpio.c
> @@ -538,7 +538,7 @@ static struct irq_chip meson_gpio_irq_chip = {
>   #ifdef CONFIG_SMP
>   	.irq_set_affinity	= irq_chip_set_affinity_parent,
>   #endif
> -	.flags			= IRQCHIP_SET_TYPE_MASKED,
> +	.flags			= IRQCHIP_SET_TYPE_MASKED | IRQCHIP_SKIP_SET_WAKE,
>   };
>   
>   static int meson_gpio_irq_domain_translate(struct irq_domain *domain,
>
> ---
> base-commit: a90ee4305c4a5df72c11b31dacfdc76e00fcf78a
> change-id: 20261008-meson-gpio-wake-f3bfa3bb2e5a
>
> Best regards,