Re: [PATCH v2 3/4] arm64: dts: qcom: nord-rrd: Enable USB ports

[Dmitry Baryshkov]

On Tue, Sep 22, 2026 at 05:01:09PM +0200, Bartosz Golaszewski wrote:
> From: Shawn Guo <shengchao.guo@xxxxxxxxxxxxxxxx>
> 
> Describe the RRD USB topology. Enable i2c9 and add the two NXP PTN3222
> eUSB2 repeaters for USB_0 and USB_1, supplied from vreg_l3l_1p8 and a new
> fixed 3.3 V pre-regulator, and reset through pmau0102_i GPIOs 9 and 10.
> 
> Add the onsemi FUSB15201 Type-C controller at 0x50 with its interrupt and
> pinctrl state on pmau0102_i gpio8. Unlike RIDE, only port A of
> the controller is wired on this board, to USB_0, so a single
> usb-c-connector is described and port B is left out. USB_0 is configured
> for OTG with usb-role-switch and its HS and SS endpoints are linked to
> the dwc3 HS endpoint and the QMP combo PHY SS output.
> 
> USB_1 is a fixed host port feeding an on-board Genesys Logic GL3590 USB
> 3.1 hub. Add the HS and SS hub pair as children of USB_1, linked with
> peer-hub, with the HS half reset via TLMM GPIO 170 and the SS half
> additionally supplied by a fixed 1.2 V rail.
> 
> Assisted-by: LLM
> Reviewed-by: Abel Vesa <abel.vesa@xxxxxxxxxxxxxxxx>
> Signed-off-by: Shawn Guo <shengchao.guo@xxxxxxxxxxxxxxxx>
> Co-developed-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxxxxxxxx>
> Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/nord-rrd.dts | 166 ++++++++++++++++++++++++++++++++++
>  1 file changed, 166 insertions(+)
> 

With the order of regulators fixed:

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxxxxxxxx>



-- 
With best wishes
Dmitry