Re: [PATCH net-next v2 1/2] dt-bindings: net: realtek,rtl82xx: document RTL8224 packages

[Krzysztof Kozlowski]

On Mon, Oct 05, 2026 at 11:15:39PM +0300, Oskari Lemmela wrote:
> RTL8224 packages contain four PHYs at consecutive MDIO addresses,
> but the first address need not be a multiple of four. Document how
> to describe these packages using the existing ethernet-phy-package
> binding so their base address is explicit.
> 
> Clarify that child PHY addresses are absolute and that MDI pair
> order and polarity properties describe the individual ports. Add
> an example with a package starting at address 1.
> 
> Signed-off-by: Oskari Lemmela <oskari@xxxxxxxxxxx>
> ---
>  .../bindings/net/realtek,rtl82xx.yaml         | 52 +++++++++++++++++--
>  1 file changed, 49 insertions(+), 3 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/net/realtek,rtl82xx.yaml b/Documentation/devicetree/bindings/net/realtek,rtl82xx.yaml
> index 07b39ef1fc62..ca52c3ae19f7 100644
> --- a/Documentation/devicetree/bindings/net/realtek,rtl82xx.yaml
> +++ b/Documentation/devicetree/bindings/net/realtek,rtl82xx.yaml
> @@ -12,7 +12,17 @@ maintainers:
>    - Heiner Kallweit <hkallweit1@xxxxxxxxx>
>  
>  description:
> -  Bindings for Realtek RTL82xx PHYs
> +  Bindings for Realtek RTL82xx PHYs.
> +
> +  The RTL8224 contains four PHYs at consecutive MDIO addresses. Its PHY
> +  nodes may be grouped under an ethernet-phy-package node as described
> +  in ethernet-phy-package.yaml. The package reg must identify the first
> +  PHY's MDIO address, even if that PHY has no child node. This address
> +  need not be a multiple of four. Each child PHY reg is its absolute
> +  MDIO address, not an offset from the package base.
> +
> +  The enet-phy-pair-order and enet-phy-pair-polarity properties belong
> +  to the individual PHY nodes and describe each port's MDI wiring.
>  
>  properties:
>    compatible:
> @@ -90,9 +100,45 @@ examples:
>          #address-cells = <1>;
>          #size-cells = <0>;
>  
> -        ethphy1: ethernet-phy@1 {
> +        ethernet-phy@1 {
>              reg = <1>;
> -            realtek,clkout-disable;
>              realtek,aldps-enable;
> +            realtek,clkout-disable;
> +        };
> +    };
> +  - |
> +    mdio {
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +
> +        ethernet-phy-package@1 {
> +            reg = <1>;
> +            #address-cells = <1>;
> +            #size-cells = <0>;
> +
> +            ethernet-phy@1 {
> +                compatible = "ethernet-phy-ieee802.3-c45";

I don't fully get why you are adding to the example generic compatibles,
not relevant to this binding.

> +                reg = <1>;
> +                enet-phy-pair-order = <0>;
> +            };

Best regards,
Krzysztof