[PATCH v2 1/2] arm64: dts: qcom: monaco-arduino-monza: Enable I2C0 and SPI3 for 40-pin JHAT connector

[Srinivas Kandagatla]

Enable i2c0 and spi3 interfaces that are exposed on the 40-pin JHAT
connector and add the corresponding i2c0 and spi0 aliases for them.

Reviewed-by: Loic Poulain <loic.poulain@xxxxxxxxxxxxxxxx>
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxxxxxxxx>
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/monaco-arduino-monza.dts | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/monaco-arduino-monza.dts b/arch/arm64/boot/dts/qcom/monaco-arduino-monza.dts
index 940a03732eef..2fa652f3ae58 100644
--- a/arch/arm64/boot/dts/qcom/monaco-arduino-monza.dts
+++ b/arch/arm64/boot/dts/qcom/monaco-arduino-monza.dts
@@ -19,9 +19,11 @@ / {
 
 	aliases {
 		ethernet0 = &ethernet0;
+		i2c0 = &i2c0;
 		i2c1 = &i2c1;
 		serial0 = &uart7;
 		serial1 = &uart10;
+		spi0 = &spi3;
 	};
 
 	chosen {
@@ -388,6 +390,11 @@ queue3 {
 	};
 };
 
+/* JHAT 40-pin I2C0 */
+&i2c0 {
+	status = "okay";
+};
+
 &i2c12 {
 	clock-frequency = <400000>;
 
@@ -562,6 +569,11 @@ &pcieport1 {
 	reset-gpios = <&tlmm 23 GPIO_ACTIVE_LOW>;
 };
 
+/* JHAT 40-pin SPI */
+&spi3 {
+	status = "okay";
+};
+
 &thermal_zones {
 	cpuss-0-0-thermal {
 		trips {
-- 
2.53.0