Re: [PATCH v3 3/7] regulator: pm8008: Add mode voting support for PM8010

[Konrad Dybcio]

On 10/30/26 7:20 AM, Jishnu Prakash wrote:
> From: Dhruvin Rajpura <drajpura@xxxxxxxxxxxxxxxx>
> 
> Implement set_mode/get_mode support for PM8010 LDOs using the mode
> control and status registers to allow clients to vote for LDO modes.
> Mode voting is not supported in the PM8008 LDOs.
> 
> Signed-off-by: Dhruvin Rajpura <drajpura@xxxxxxxxxxxxxxxx>
> Signed-off-by: Jishnu Prakash <jishnu.prakash@xxxxxxxxxxxxxxxx>
> ---

This defers the modesetting to the consumer. Please take a look at
the qcom-rpmh-regulator driver and implement something like this:

static unsigned int rpmh_regulator_vrm_get_optimum_mode(
        struct regulator_dev *rdev, int input_uV, int output_uV, int load_uA)
{
        struct rpmh_vreg *vreg = rdev_get_drvdata(rdev);

        if (load_uA >= vreg->hw_data->hpm_min_load_uA)
                return REGULATOR_MODE_NORMAL;
        else
                return REGULATOR_MODE_IDLE;
}

and fill out the max current allowed for LPM for each regulator

Konrad