Re: [PATCH RFC] drm/dp_tunnel: Allow BWA when the DP IN adapter does not advertise it
From: Mika Westerberg
Date: Mon Nov 02 2026 - 08:07:51 EST
Hi,
On Sat, Oct 31, 2026 at 01:18:18AM +0100, Diego Noguês via B4 Relay wrote:
> From: Diego Noguês <diego.sure@xxxxxxxxx>
>
> On an Alder Lake host (i7-1265U) with a Thunderbolt 4 dock (Dell WD22TB4,
> Goshen Ridge) driving two 4K@60 monitors through two DP tunnels, the
> monitor whose tunnel is created second is limited to 4K@30. Which monitor
> is affected depends only on the order in which they are powered on.
>
> The thunderbolt driver enables the BW allocation mode (BWA) on both DP IN
> adapters: it sets the CM BWA support (DP_USB4_DRIVER_BW_CAPABILITY), a
> group ID and the estimated BW. The DP IN adapter, however, never sets
> DP_IN_BW_ALLOCATION_MODE_SUPPORT in DP_TUNNELING_CAPABILITIES (0xe000d
> reads 0x01), so tunnel_regs_are_valid() rejects the tunnel with:
Alder Lake firmware really does not support this and by forcing it to be
enabled you may end up in untested code paths and interesting behavior :)
BWA was only officially supported starting from Meteor Lake.