Re: [PATCH v5 4/8] dt-bindings: iio: imu: Add bindings for ADI ADIS16607

[Krzysztof Kozlowski]

On Mon, Nov 02, 2026 at 07:36:00PM +0000, Conor Dooley wrote:
> On Mon, Nov 02, 2026 at 11:25:40AM +0200, Radu Sabau via B4 Relay wrote:
> > From: Radu Sabau <radu.sabau@xxxxxxxxxx>
> > 
> > Add device tree bindings for the Analog Devices ADIS16607 Precision
> > MEMS Inertial Measurement Unit. The ADIS16607 integrates a triaxial
> > gyroscope, triaxial accelerometer, and temperature sensor, and
> > communicates over SPI Half-Duplex.
> > 
> > Two variants are supported, adis16607-2 and adis16607-3, differing
> > only in gyroscope full-scale range (±450°/s and ±2000°/s
> > respectively).
> > 
> > The binding exposes optional properties for:
> >   - An external clock for sync mode (falling back to the internal 8 kHz
> >     clock when absent)
> >   - A hardware reset GPIO (active low)
> > 
> > Signed-off-by: Radu Sabau <radu.sabau@xxxxxxxxxx>
> 
> Why did you drop Rob's tag?

Explanation in cover letter is confusing. There is no difference between
v4 and v5. There is some description change betweeb v3 and v5. So was
the description change something forcing to re-review?

Radu, please carefully read submitting patches.

Best regards,
Krzysztof