[PATCH net-next 0/2] net: dsa: mxl-gsw1xx: reset the switch through reset-gpios

[Joseph Telaak via B4 Relay]

The GSW1xx driver never resets the switch, and the MDIO core does not
handle reset-gpios for non-PHY devices, so the driver works with whatever
the bootloader configured. On the GL.iNet GL-SFT1200 (SiFlower SF19A2890 +
GSW150) the bootloader leaves the internal PHYs one MDIO address too high,
and the WAN port has no PHY.

Patch 1 allows reset-gpios in the binding for the standalone switches.
Patch 2 pulses it at probe.

This is separate from commit 82e2c7db0830 ("net: dsa: mxl-gsw1xx: force
internal PHYs into a known reset state"), which only programs the PHY
bits of RST_REQ. On this board that commit is applied, and the PHYs still
sit at the shifted addresses; only a hardware reset of the switch moves
them back.

Tested on a GL.iNet GL-SFT1200 (Intel GSW150 / PEB7084 at SMI address
0x1f, reset on an active-low SoC GPIO), on the 6.18 backport that OpenWrt
carries: after a warm reboot and after a cold power-on, all three ports
find their PHYs at addresses 0 to 2 and link at 1 Gbit/s. Without the
patch, port 0 fails with -ENODEV after every boot.

The board's device tree goes to OpenWrt; there is no in-tree user yet.

---
Joseph Telaak (2):
      dt-bindings: net: dsa: lantiq,gswip: add reset-gpios
      net: dsa: mxl-gsw1xx: reset the switch through reset-gpios

 .../devicetree/bindings/net/dsa/lantiq,gswip.yaml        |  6 ++++++
 drivers/net/dsa/lantiq/mxl-gsw1xx.c                      | 16 ++++++++++++++++
 drivers/net/dsa/lantiq/mxl-gsw1xx.h                      |  4 ++++
 3 files changed, 26 insertions(+)
---
base-commit: 4dd16e31135ea8437a720222df34e8745f385d6d
change-id: 20261102-mxl-gsw1xx-reset-37ac836b31fe

Best regards,
--  
Joseph Telaak <joseph@xxxxxxxxxx>