Re: [PATCH v4 03/12] arm64: dts: qcom: hamoa-pmic: Enable BCL sensor node

[Manaf Meethalavalappu Pallikunhi]

Hi Konrad,

On 10/19/2026 8:21 PM, Konrad Dybcio wrote:
> On 10/5/26 2:24 PM, Manaf Meethalavalappu Pallikunhi wrote:
> > Add Battery Current Limiting (BCL) hardware monitor node for
> > hamoa-pmic. The BCL monitors battery voltage and current, providing
> > hardware interrupts when configurable thresholds are violated.
> >
> > Reviewed-by: Abel Vesa <abel.vesa@xxxxxxxxxxxxxxxx>
> > Signed-off-by: Manaf Meethalavalappu Pallikunhi <manaf.pallikunhi@xxxxxxxxxxxxxxxx>
> > ---
>
> [...]
>
> > @@ -674,6 +685,17 @@ smb2360_0: pmic@7 {
> >   
> >   		status = "disabled";
> >   
> > +		sensor@4700 {
>
> Is it not there on the 4 other SMB2360s?

No. The BCL peripheral is enabled only on the first SMB2360. AFAIK, the 
other four are used only for USB functionality.

Thanks,
Manaf

> Konrad
>
> > +			compatible = "qcom,smb2360-bcl";
> > +			reg = <0x4700>;
> > +			interrupts = <0x7 0x47 0x0 IRQ_TYPE_EDGE_RISING>,
> > +				     <0x7 0x47 0x1 IRQ_TYPE_EDGE_RISING>,
> > +				     <0x7 0x47 0x2 IRQ_TYPE_EDGE_RISING>;
> > +			interrupt-names = "max-min",
> > +					  "critical",
> > +					  "emergency";
> > +		};
> > +
> >   		smb2360_0_eusb2_repeater: phy@fd00 {
> >   			compatible = "qcom,smb2360-eusb2-repeater";
> >   			reg = <0xfd00>;