Re: [PATCH v11 01/19] spi: dt-bindings: add spi-max-post-config-frequency-hz property

[Krzysztof Kozlowski]

On 05/11/2026 17:41, Krzysztof Kozlowski wrote:
> On 05/11/2026 11:58, Santhosh Kumar K wrote:
>> Add spi-max-post-config-frequency-hz, a generic property for SPI
>> peripherals that operate at two distinct clock rates: a conservative
>> rate always reachable without controller configuration, and a higher
>> rate achievable only after controller-side configuration.
>>
>> When both properties are present, spi-max-frequency gives the
>> conservative pre-configuration rate and spi-max-post-config-frequency-hz
>> gives the higher post-configuration target.
>>
>> Acked-by: Conor Dooley <conor.dooley@xxxxxxxxxxxxx>
>> Tested-by: Srikanth Boyapally <srikanth.boyapally@xxxxxxx>
>> Tested-by: Moteen Shah <m-shah@xxxxxx>
> 
> Drop tags, this did not happen. Please do not add blindly tags which are

^ tested-by tags, I meant. Acked was correct.

> obviously not applicable.
> 
> Best regards,
> Krzysztof


Best regards,
Krzysztof