Re: [PATCH v2 00/10] soundwire: Fix Critical and High issues reported by Sashiko

[HyeongJun An]

On a Dell Latitude 9420 (Tiger Lake, SOF IPC3, sof_sdw with rt711-sdca
on link 0, two rt1316 on links 1 and 2 that are aggregated into one
Speaker stream, and rt714 on link 3), I tested this series on top of
soundwire next at commit afd88e7ad781. Only patches 1-4 run on this
machine. The intel_ace2x and qcom patches are not exercised here.

With and without the series:
- all four peripherals attach at boot
- playback and capture work on every endpoint
- 40 start/stop cycles of the multi-link Speaker stream (10 of them
  after the links had runtime suspended), all links streaming at the
  same time, and Jack Out start/stop while Speaker was playing all
  passed
- ALSA pcm-test: 24 pass, 0 fail
- the dev-properties, dp0 and dpN sysfs attributes of all four
  peripherals read back identical (the words arrays are empty on these
  codecs, so only the trailing newline goes through the changed code)

With the series, s2idle with Speaker playback and Microphone capture
running: all four peripherals were attached again after resume, both
streams continued after aplay/arecord re-prepared them, and playback and
capture on every endpoint still worked. There were no SoundWire or SOF
kernel messages. I did not run the same s2idle test without the series.

These runs only take the normal paths, so the failure cases that
patches 3 and 4 guard against were not hit.

I ran these with Claude Code (Claude Opus 5.5) on the laptop.

I am sending Tested-by on patches 1-4 only, in replies to those
patches.