Re: [PATCH v5 4/4] iio: cdc: add Texas Instruments FDC1004 driver

[Jonathan Cameron]

On Fri,  6 Nov 2026 09:40:29 -0600
Victor Chernyakin <chernyakin.victor.j@xxxxxxxxxxx> wrote:

> The FDC1004 is a high-precision 4-channel capacitive sensor that talks
> over I2C. It can report the values of each of its 4 channels individually,
> as well as the difference between any two of them.
> 
> This initial driver allows performing single reads and configuring
> the sensor's various settings (sample frequency, calibration
> gain/offset, etc.). It could be extended with support for triggered
> buffers, repeated measurement mode, and/or power management.
> 
> Signed-off-by: Victor Chernyakin <chernyakin.victor.j@xxxxxxxxxxx>
I took another read through and didn't spot anything else.
So fingers crossed for v6 after you fix those sashiko warnings.

If there are some you disagree with that aren't obviously garbage
(which is less common by far than it was) then reply to this thread
pasting them in with appropriate context and say why they are wrong.

Thanks,

Jonathan