[PATCH 0/3] drm/panel: Add Anapass ANA38407 DDIC

[Nizat Mikayilli via B4 Relay]

This series adds a driver for the Samsung AMSA10FA01, the 2560x1600
AMOLED panel of the Samsung Galaxy Tab S9 Wi-Fi (SM8550). It is a
command mode DSI panel with DSC, driven by an Anapass ANA38407 DDIC.
The binding and driver are named after the DDIC.

Only the 120 Hz mode of panel revision D is supported. The init
sequence comes from the vendor panel data, without the
brightness-dependent gamma, HBM and ELVSS writes. A fixed delay
replaces the vendor's wait on the TCON_RDY pin.

Tested on the tablet: cold and warm boot, hand-off from the bootloader
splash, brightness and blank/unblank. The board DT follows separately.

Signed-off-by: Nizat Mikayilli <nacht@xxxxxxxxxx>
---
Nizat Mikayilli (3):
      dt-bindings: vendor-prefixes: Add Anapass
      dt-bindings: display: panel: Document Anapass ANA38407 DDIC
      drm/panel: Add driver for Anapass ANA38407 DDIC

 .../bindings/display/panel/anapass,ana38407.yaml   |  69 +++++
 .../devicetree/bindings/vendor-prefixes.yaml       |   2 +
 MAINTAINERS                                        |   6 +
 drivers/gpu/drm/panel/Kconfig                      |  15 +
 drivers/gpu/drm/panel/Makefile                     |   1 +
 drivers/gpu/drm/panel/panel-anapass-ana38407.c     | 320 +++++++++++++++++++++
 6 files changed, 413 insertions(+)
---
base-commit: 6628e7d4c6b25c8d18f1345e3a20d21829aae7e4
change-id: 20261107-b4-ana38407-31955acb84a7

Best regards,
-- 
Nizat Mikayilli <nacht@xxxxxxxxxx>