Re: 回覆: 回覆: [PATCH net-next v5 1/7] dt-bindings: net: ftgmac100: Make Aspeed compatibles standalone

From: Andrew Lunn

Date: Sat Nov 07 2026 - 15:45:15 EST


On Thu, Nov 05, 2026 at 12:49:28PM +0000, Jacky Chou wrote:
> > > > > The aspeed,ast2400-mac, aspeed,ast2500-mac, and aspeed,ast2600-mac
> > > > > compatibles are currently only valid when paired with the generic
> > > > > "faraday,ftgmac100" fallback: if a node ever bound through the
> > > > > generic entry alone, ftgmac100_probe() would set
> > > > > rxdes0_edorr_mask/txdes0_edotr_mask to BIT(15) instead of the
> > > > > Aspeed BIT(30), skip Aspeed clock setup, and leave the DMA mask too
> > narrow.
> > > >
> > > > And device would work or not? If device still works after all these
> > > > steps above, then why isn't fallback applicable?
> > > >
> > > > Be explicit, because I have no clue whether Aspeed clock setup is
> > > > necessary for device to operate.
> > > >
> > >
> > > It is necessary: ftgmac100_setup_clk() enables the MAC's clock, and
> > > only runs when priv->is_aspeed is true - skipped if a node ever bound
> > > through the generic entry. Without ftgmac100_setup_clk(), the MAC on
> >
> > This part is obvious.
> >
> > > Aspeed platform would be left without a working clock, so it wouldn't
> > > be able to configure register and TX/RX at all.
> >
> > So you are saying device will not work? Then make it obvious that clock is
> > necessary for basic register access.
> >
>
> Yes, the MAC on Aspeed platform does not work at all. Without the clock, even basic register
> access to the MAC is not possible.

Then for this new compatible you can mark it required.

Maybe test what happens if you mark it required for all aspeed
compatibles. Do an .dts files fail the test tools?

Andrew