[PATCH 0/2] clk: sunxi-ng: h616: Fix the EMAC 25 MHz and S/PDIF clocks
From: Arun Iyengar via B4 Relay
Date: Tue Nov 10 2026 - 01:03:12 EST
Two small fixes for the H616 CCU, found while checking the clock tree of
an Orange Pi Zero2 against the H616 user manual.
Patch 1 models the EPHY 25 MHz clock as PLL_PERI0 / 24, as the manual
describes it. Only the parent and the reported rate change; the register
writes are the same.
Patch 2 lets the S/PDIF clock change the audio PLL rate, so the 44.1 kHz
and 48 kHz families both get the right module clock. It is the H616
counterpart of the H6 patch that was just applied [1].
Tested on an Orange Pi Zero2 (H616) with a 7.3 kernel carrying both
patches:
- clk_summary shows emac-25m at 25000000 with pll-periph0 (600 MHz) as
its parent (200000000 below ahb3 before). The Zero2 uses an external
RGMII PHY on EMAC0, so nothing on this board consumes the clock; only
the clock tree was checked.
- With the S/PDIF output enabled, the spdif clock is 24576000 Hz under
aplay at 48 kHz and 22579200 Hz at 44.1 kHz. I have no S/PDIF receiver,
so the output itself was not checked on the wire.
These patches were developed with Claude (Anthropic) as a coding
assistant. It investigated the problem and wrote the code and the commit
messages; I reviewed them, and they were tested on an Orange Pi Zero2
(H616) as described above.
[1] https://lore.kernel.org/all/20261104185027.883011-1-jernej.skrabec@xxxxxxxxx/
---
Arun Iyengar (2):
clk: sunxi-ng: h616: Fix the EMAC 25 MHz clock parent and divider
clk: sunxi-ng: h616: Let the S/PDIF clock set the audio PLL rate
drivers/clk/sunxi-ng/ccu-sun50i-h616.c | 15 ++++++++++++---
1 file changed, 12 insertions(+), 3 deletions(-)
---
base-commit: 280af24c860569000b375edda6436ba8e3ee4b3a
change-id: 20261110-h616-clk-emac-spdif-411c96dfbde2
Best regards,
--
Arun Iyengar <aiyengar1990@xxxxxxxxx>