Re: [PATCH] clk: rockchip: rk3588: Allow I2S5 TX and I2S6 RX frac to set parent rate
From: Heiko Stübner
Date: Wed Nov 11 2026 - 17:23:37 EST
Am Mittwoch, 11. November 2026, 23:06:53 Mitteleuropäische Normalzeit schrieb Tim Surber:
> All RK3588 audio fractional dividers except clk_i2s5_8ch_tx_frac and
> clk_i2s6_8ch_rx_frac are registered with CLK_SET_RATE_PARENT. Without it
> the divider cannot raise the rate of its *_src parent again once the
> parent has been lowered.
>
> That happens on HDMI0 (i2s5_8ch) after a 192 kHz stream. Its MCLK of
> 24.576 MHz (128 * fs) is an integer divisor of AUPLL (786.432 MHz / 32),
> so the mux selects clk_i2s5_8ch_tx_src directly and sets its divider to
> 32. For a following 176.4 kHz stream the mux selects the fractional
> divider. rockchip_fractional_approximation() sees that the parent is
> less than 20 times the requested rate and computes m/n against the
> grandparent (AUPLL) rate, but the parent is never changed. The divider
> is then programmed with m/n = 147/160 from 24.576 MHz. The clock
> framework reports the requested 22.5792 MHz, but the fractional divider
> does not work at such a ratio and the I2S runs at about 54% of the
> nominal rate (96000 instead of 176400 frames/s).
>
> Add CLK_SET_RATE_PARENT to both dividers, as on all other I2S and SPDIF
> fractional dividers of the RK3588 and as in the vendor kernel:
>
> https://github.com/rockchip-linux/kernel/blob/470f9dccbdc42e7b8a824d0a5c5640a10e9457d2/drivers/clk/rockchip/clk-rk3588.c#L2037
> https://github.com/rockchip-linux/kernel/blob/470f9dccbdc42e7b8a824d0a5c5640a10e9457d2/drivers/clk/rockchip/clk-rk3588.c#L2055
>
> To reproduce, on any RK3588 board with HDMI0 audio enabled and a sink
> that accepts 192 and 176.4 kHz LPCM: play 192 kHz, then time two
> seconds of 176.4 kHz:
>
> aplay -q -D hw:HDMI0 -t raw -f S16_LE -c 2 -r 192000 -d 1 /dev/zero
> time aplay -q -D hw:HDMI0 -t raw -f S16_LE -c 2 -r 176400 -d 2 /dev/zero
>
> On linux-rockchip for-next the second command takes 3.7 s instead of
> 2.0 s, and clk_i2s5_8ch_tx_src stays at 24.576 MHz.
>
> Tested on a FriendlyElec CM3588 NAS with HDMI0 cabled into its HDMI
> receiver, the receiver's EDID advertising 192 and 176.4 kHz, and the
> HDMI sound cards enabled in the device tree. Two 176.4 kHz runs after
> boot, then three runs each preceded by a 192 kHz stream:
>
> 176.4 kHz frames/s clk_i2s5_8ch_tx_src
> after boot / after after the 176.4 kHz
> 192 kHz stream (Hz)
> for-next 175500 / 95600 (3x) 24576000
> for-next + this patch 175500 / 174800 (3x) 786431991
>
> With this patch the 32 to 192 kHz rates still play at their nominal
> rate, and a frame counter played at 176.4 kHz after a 192 kHz stream
> was captured bit-exact by the HDMI receiver. I2S6 RX is not used on
> this board and was not tested.
>
> Fixes: f1c506d152ff ("clk: rockchip: add clock controller for the RK3588")
> Signed-off-by: Tim Surber <me@xxxxxxxxxxxx>
This is waaaay too long for a siomple two line change. Please shorten
this to a sane level.
Thanks
Heiko
> ---
> drivers/clk/rockchip/clk-rk3588.c | 6 ++++--
> 1 file changed, 4 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/clk/rockchip/clk-rk3588.c b/drivers/clk/rockchip/clk-rk3588.c
> index 24baa0ef9..63aeeb501 100644
> --- a/drivers/clk/rockchip/clk-rk3588.c
> +++ b/drivers/clk/rockchip/clk-rk3588.c
> @@ -2024,7 +2024,8 @@ static struct rockchip_clk_branch rk3588_early_clk_branches[] __initdata = {
> COMPOSITE(CLK_I2S5_8CH_TX_SRC, "clk_i2s5_8ch_tx_src", gpll_aupll_p, 0,
> RK3588_CLKSEL_CON(140), 10, 1, MFLAGS, 5, 5, DFLAGS,
> RK3588_CLKGATE_CON(62), 6, GFLAGS),
> - COMPOSITE_FRACMUX(CLK_I2S5_8CH_TX_FRAC, "clk_i2s5_8ch_tx_frac", "clk_i2s5_8ch_tx_src", 0,
> + COMPOSITE_FRACMUX(CLK_I2S5_8CH_TX_FRAC, "clk_i2s5_8ch_tx_frac", "clk_i2s5_8ch_tx_src",
> + CLK_SET_RATE_PARENT,
> RK3588_CLKSEL_CON(141), 0,
> RK3588_CLKGATE_CON(62), 7, GFLAGS,
> &rk3588_i2s5_8ch_tx_fracmux),
> @@ -2043,7 +2044,8 @@ static struct rockchip_clk_branch rk3588_early_clk_branches[] __initdata = {
> COMPOSITE(CLK_I2S6_8CH_RX_SRC, "clk_i2s6_8ch_rx_src", gpll_aupll_p, 0,
> RK3588_CLKSEL_CON(146), 7, 1, MFLAGS, 2, 5, DFLAGS,
> RK3588_CLKGATE_CON(63), 0, GFLAGS),
> - COMPOSITE_FRACMUX(CLK_I2S6_8CH_RX_FRAC, "clk_i2s6_8ch_rx_frac", "clk_i2s6_8ch_rx_src", 0,
> + COMPOSITE_FRACMUX(CLK_I2S6_8CH_RX_FRAC, "clk_i2s6_8ch_rx_frac", "clk_i2s6_8ch_rx_src",
> + CLK_SET_RATE_PARENT,
> RK3588_CLKSEL_CON(147), 0,
> RK3588_CLKGATE_CON(63), 1, GFLAGS,
> &rk3588_i2s6_8ch_rx_fracmux),
>
> base-commit: c3baae5f1a15645cddadcb2b9abddef5df291f59
>