Re: [PATCH 0/2] iommu/sun50i: Don't report TLB prefetch walks as page faults

From: Arun Iyengar

Date: Thu Nov 12 2026 - 03:16:56 EST


Hi Jernej,

On Tue, Nov 10, 2026, Jernej Skrabec wrote:
> First off, display engine isn't in merged yet. Second, I don't observe any
> such issues with my wip H616 code.
>
> I think it's best to wait until driver is merged and can be retested and
> merged then, if needed.

Agreed, thanks. In mainline the only H616 IOMMU master today is the video
engine, and the faults I saw came from the display scanning out a
framebuffer through the IOMMU, with the out-of-tree DE33 code I use. I'll
drop this series for now and retest once the display driver is merged.

Out of curiosity: does your WIP code map the framebuffer through the IOMMU?
In the boots where fbcon takes over the display, the fbcon buffer
(1024x768, 3 MiB) is the first IOVA allocation, so it ends right below
the top 1 MiB, which stays unmapped, and the prefetch walk for the page
after it fails.

Best regards,
Arun

On Tue, Nov 10, 2026 at 8:04 AM Jernej Škrabec <jernej.skrabec@xxxxxxxxx> wrote:
>
> Dne torek, 10. november 2026 ob 07:05:16 Srednjeevropski standardni čas je Arun Iyengar via B4 Relay napisal(a):
> > On an H616 with a display scanning out, the IOMMU reports page faults
> > with master -1 at the IOVA right after the end of the framebuffer: once
> > at the first fbcon frame, and then once per frame for a while after
> > each TLB flush, e.g. while a video decoder frees its buffers. They are
> > failed walks of the TLB prefetcher, which the hardware flags with bit 31
> > of the page table interrupt registers and no master bit. Patch 1 stops
> > reporting them. Patch 2 makes the remaining fault messages say which
> > walk failed and what the interrupt register held.
> >
> > Tested on an Orange Pi Zero2 (H616) with HDMI forced on at 1024x768 and
> > three 4K H.264 decodes through cedrus, on 7.3 kernels with and without
> > the patches:
> > - without: 214 "Page fault ... (master -1, dir rd)" lines;
> > - with: none, no "Page fault" line at all, and no decode errors or
> > timeouts.
> > Since the patched kernel prints every fault that is not a masterless
> > prefetch walk, this also shows that the hardware sets bit 31 for these
> > walks.
>
> First off, display engine isn't in merged yet. Second, I don't observe any
> such issues with my wip H616 code.
>
> I think it's best to wait until driver is merged and can be retested and
> merged then, if needed.
>
> Best regards,
> Jernej
>
> >
> > These patches were developed with Claude (Anthropic) as a coding
> > assistant. It investigated the problem and wrote the code and the commit
> > messages; I reviewed them, and they were tested on an Orange Pi Zero2
> > (H616) as described above.
> >
> > ---
> > Arun Iyengar (2):
> > iommu/sun50i: Don't report TLB prefetches of unmapped pages as faults
> > iommu/sun50i: Print the page table level and status of a fault
> >
> > drivers/iommu/sun50i-iommu.c | 50 ++++++++++++++++++++++++++++++++++----------
> > 1 file changed, 39 insertions(+), 11 deletions(-)
> > ---
> > base-commit: 2cf4be57b301ed2d7af82e70cff5dfd96894d8de
> > change-id: 20261110-sun50i-iommu-prefetch-85cc9ecff559
> >
> > Best regards,
> > --
> > Arun Iyengar <aiyengar1990@xxxxxxxxx>
> >
> >
> >
>
>
>
>