Re: [PATCH net-next v4 0/5] net: devmem: size TX net_iovs from the dmabuf layout
From: Paolo Abeni
Date: Thu Nov 12 2026 - 03:41:40 EST
Hi,
A few (late) questions/comments to check I'm not missing relevant
points,
On 11/11/26 23:47, Stanislav Fomichev wrote:
TX bindings use PAGE_SIZE net_iovs, so a frag covers at most a page.
A 64KB skb needs 16 frags, and MAX_SKB_FRAGS caps devmem skbs at about
68KB, which makes BIG TCP ineffective for devmem TX.
... with default .config. You could set MAX_SKB_FRAGS to 45 and reach
~180K...
This series picks the TX net_iov size from the dmabuf sg table instead:
the largest power of 2, up to 2MB, which aligns every DMA segment. With
a 2MB hugepage-backed udmabuf a BIG TCP skb takes a few frags. There's
no UAPI change since TX addresses are dmabuf offsets.
... still this option should be more effective because the limit would be
higher and the skb would use less cachelines for the shared_info,
I'm wondering if making a comparison vs MAX_SKB_FRAGS==45 would be
complex and if you could do that, too.
This doesn't make skbs larger. TCP still sizes them with size_goal.
Only the frags get larger, and a single frag can now cover the whole
skb.
An skb stays under 64KB unless BIG TCP is enabled. With BIG TCP,
MSG_ZEROCOPY from huge pages can already create frags of 64KB or
more. So drivers already have to handle them:
- mlx5 has a 31-bit length per data segment
- gve splits frags into 16KB descriptors
- fbnic doesn't enable BIG TCP
- bnxt has a 16-bit BD length. It is broken for such page frags today
and will be fixed separately.
Tested on two mlx5 400Gb/s hosts with kperf (udmabuf, 32KB RX
net_iovs, 2MB hugepage-backed TX buffer), series backported to a 7.1
kernel on the sender only. 1 flow, MTU 4200, receiver tcp_rmem capped
at 16MB so it doesn't drop, median of 5 x 60s runs:
before after
frags per skb (sender) 16-17 1-2
throughput (Gb/s) 208.6 211.2
sender sendmsg CPU (sys) 40.8% 19.5% (-52%)
The receiver's CPU is the bottleneck, so the gain is CPU, not
throughput. More of the transmit runs from the ACK path, so the
sender's softirq grows (52% -> 59%), but sys + sirq still drops by 16%.
is the receiver using GRO H/W offload/big TCP? Which are the gro_max_size/
gso_max_size limits? In the `after` scenario, is the 2nd frag used for the
headers?
Thanks,
Paolo