Re: [PATCH v3 0/2] ARM: dts: zynq: Add ALINX AX7Z020B development board
From: Michal Simek
Date: Fri Nov 13 2026 - 09:13:39 EST
On 11/12/26 20:32, Pufan Jin wrote:
Add devicetree support for the ALINX AX7Z020B board, built around theApplied.
ALINX AC7Z020 system on module with a Zynq-7000 (XC7Z020-2CLG400I) SoC.
Changes in v3:
- Drop the vendor website Link: tags (Krzysztof Kozlowski).
- Drop the empty bootargs property (Krzysztof Kozlowski).
- Rename the USB PHY node from phy0 to phy, as there is only one USB PHY
on the board (Krzysztof Kozlowski).
- Keep the explicit mdio node under gem0, as requested during the v1
review and reviewed by Andrew Lunn in v2. dtc W=1 flags the parent
node's inherited #address-cells/#size-cells. DT schema validation
reports the same Zynq-7000 diagnostics as zynq-zybo-z7. The MDIO
layout was also verified on hardware.
- Sort I2C child nodes by address and reorder status/reg properties.
- Add Krzysztof's Acked-by to patch 1.
The "alinx" vendor prefix is already queued in linux-next as commit
1f06cd374a60 ("dt-bindings: vendor-prefixes: Add ALINX vendor prefix"),
so it is not part of this series.
Tested on hardware before the DTS style reordering: SD boot, UART
console, SD card, GbE (900+ Mbps and LED hardware offload), dual CAN,
I2C, QSPI and XADC.
Pufan Jin (2):
dt-bindings: soc: xilinx: Add ALINX AX7Z020B board
ARM: dts: zynq: Add ALINX AX7Z020B development board
.../bindings/soc/xilinx/xilinx.yaml | 5 +
arch/arm/boot/dts/xilinx/Makefile | 1 +
.../boot/dts/xilinx/zynq-alinx-ac7z020.dtsi | 71 +++++++++
.../boot/dts/xilinx/zynq-alinx-ax7z020b.dts | 146 ++++++++++++++++++
4 files changed, 223 insertions(+)
create mode 100644 arch/arm/boot/dts/xilinx/zynq-alinx-ac7z020.dtsi
create mode 100644 arch/arm/boot/dts/xilinx/zynq-alinx-ax7z020b.dts
M