Re: [PATCH v17 1/3] pmdomain: rockchip: switch off the subdomains of a regulator domain at probe
From: Vladimir Bely
Date: Sat Nov 14 2026 - 04:45:26 EST
On Sat, Nov 14, 2026 at 04:04:59PM +1300, Jiaxing Hu wrote:
> Mark a regulator domain and every domain below it as off when it is
> added, and once the subtree is complete, switch it off from the leaves
> up. If a subdomain fails to switch off, leave its parents on and warn.
I tested this patch on the board I reported the hang on, a FriendlyElec
NanoPi R76S (RK3576), and it fixes it.
What I ran: Armbian's 7.3.4 edge kernel (armbian/build main, which
carries v14 of the RK3576 NPU series, so PD_NPU already needs a
regulator there) plus this patch as armbian/build#11366 carries it.
The code is the same as this 1/3 (I compared the diff). I did not
test 2/3 and 3/3 of v17.
DT: the R76S DT with the NPU disabled, i.e. no domain-supply on pd_npu,
which is the case that hung. No regulator_ignore_unused, no
regulator-always-on. Serial console attached, warm reboots, PMU read
from the regmap debugfs about 42 s after the kernel started, after
regulator_late_cleanup() has turned vdd_npu_s0 off.
Without the patch (Armbian 7.3.3, same DT): hung on 3 of 4 boots; on
the boots that survived, NPUTOP, NPU0 and NPU1 were still powered and
not idled while genpd listed them off.
With the patch: 11 of 11 boots, no hang. "vdd_npu_s0: disabling" is
in the log on every boot, and every boot reads
without with this patch
0x110 req 0x000013e0 0x000013fe
0x214 pwr 0x0000003e 0x000001fe
so the three subdomains are idled and off before the rail goes away.
(Bit 9 of 0x214 is clear because the GPU is in use on this board.)
With the NPU enabled on the same kernel, rocket probes both cores and
an LLM runs on them, with identical output on two runs.
Tested-by: Vladimir Bely <vlwwwwww@xxxxxxxxx>
Thanks for the quick fix,
Vladimir