Re: [PATCH v3 0/9] media: i2c: ov7251: fixes and infrared strobe for Surface Book 2

From: Firas Sharary

Date: Sun Nov 15 2026 - 12:54:24 EST


Hi Antoine,

I tested this series on a Microsoft Surface Pro 7+ (IPU6 Tiger Lake,
8086:9a19, sensor INT347E, SKU Surface_Pro_7+_1960).

Setup: all nine patches on top of linux-surface 7.3.4. Patches 1 to 4
applied as they are. For 5 to 9 the only change was the pad operation
signature, since v7.3 does not pass the client info argument yet. The
tree also has "platform/x86: int3472: map the ov7251 power enable GPIO
to "vdda"", without which the sensor does not probe on this machine,
and linux-surface's V4L2_CID_ANALOGUE_GAIN rename.

Results:

- The sensor probes and streams 640x480 Y10 at 30 fps on the 319.2 MHz
link.
- Raw capture from the ISYS node, ten start/stop cycles of 15 to 20
frames: every frame arrived, none was pinned at full scale, and the
receiver logged no CSI-2 error in those runs. I had not run the old
PLL setting on this machine, so I cannot compare patch 1 with the
behaviour before it.
- With V4L2_CID_FLASH_STROBE_OE off, every frame sits at the black level
(mean 16 to 17 of 1023). With it on, frames alternate between that and
a lit frame (mean roughly 240 to 340 at the default exposure of 504
and gain 16, with a face about half a metre away). The emitter is off
whenever the sensor is not streaming.
- Patch 9: the rotation control reads 90, and the frames are upright
after turning them 90 degrees counter-clockwise.

Face authentication with Howdy works on the lit frames.

Tested-by: Firas Sharary <firassharary3@xxxxxxxxx> # Surface Pro 7+

Thanks,
Firas