RE: [PATCH v2 1/3] dt-bindings: hwmon: ltc4283: add ltc4284

From: Torreno, Alexis Czezar

Date: Sun Nov 15 2026 - 20:09:52 EST


> >
> > description: |
> > - The LTC4283 negative voltage hot swap controller drives an external
> > N-channel
> > - MOSFET to allow a board to be safely inserted and removed from a
> > live
> > - backplane.
> > + The LTC4283 and LTC4284 are negative voltage hot swap controllers
> > + that drive external N-channel MOSFETs to allow a board to be safely
> > + inserted and removed from a live backplane.
> > +
> > + The LTC4284 features dual-gate drivers with four operating modes
> > + (single driver, parallel, high stress staged start, and low stress
> > + staged start) configured via the hardware MODE pin. The MODE pin
> > + must be connected to the appropriate voltage level (VEE, VIN,
> > + INTVCC, or left open) and cannot be controlled via software or GPIO.
> >
> >
> > https://www.analog.com/media/en/technical-documentation/data-sheets/lt
> > c4283.pdf
> > +
> > + https://www.analog.com/media/en/technical-documentation/data-sheets/
> > + ltc4284.pdf
> >
> > properties:
> > compatible:
> > enum:
> > - adi,ltc4283
> > + - adi,ltc4284
> >
> > reg:
> > maxItems: 1
> >
> > adi,rsense-nano-ohms:
> > - description: Value of the sense resistor.
> > + description:
> > + Value of the sense resistor. For LTC4283, this is the resistor connected
> > + between SENSE+/SENSE- pins. For LTC4284, this is the resistor connected
> > + between SENSE1+/SENSE1- pins.
> > +
> > + adi,rsense2-nano-ohms:
> > + description:
> > + Value of the SENSE2 current sense resistor. This resistor is connected
> > + between SENSE2+ and SENSE2- pins.
> > +
> > + adi,radc-nano-ohms:
> > + description:
> > + Value of the effective resistance seen by the ADC+/ADC- pins.
>
> These two properties are not required by the device? Is there a default in such
> case?
>

'adi,radc-nano-ohms' is required for ltc4284 only (doesn't exist for ltc4283).
Sashiko found my driver patch to lack setting a default so will add that in v3.
The value is like the default of 'adi,rsense-nano-ohms', LTC4283_MIN_RSENSE.

I put 'adi,rsense2-nano-ohms' as optional, when absent it defaults to 0, the
driver then assumes it is working in single-driver mode.

Thanks,
Alexis