[PATCH] iommu/amd: Do not clear unobserved log overflow status bits

From: Guanghui Feng

Date: Sun Nov 15 2026 - 22:39:25 EST


amd_iommu_handle_irq() clears the interrupt status with an unconditional
writel(mask, MMIO_STATUS_OFFSET), where mask is int_mask | overflow_mask.
The log overflow status bits (GALOverflow, EventOverflow, PprOverflow)
are RW1C and, per the AMD IOMMU spec, transitioning them from 0 to 1 does
not itself generate an interrupt; they can only be observed by an IRQ
round triggered by the corresponding log-interrupt bit.

If hardware sets an overflow bit after the status register is sampled at
the top of the loop but before the unconditional writel(), that write
clears the freshly-set bit while the stale sampled status does not
contain it, so overflow_handler() is skipped for an overflow that really
happened. For the GA log this is fatal: amd_iommu_restart_ga_log() is the
only recovery path, and per spec section 2.7.4 logging stays halted until
GALogEn is toggled. A bare W1C of GALOverflow is not part of the
documented recovery, so the GA log stays halted, no further entries are
written, GAInt never re-asserts and the GA log interrupt line goes
permanently silent, losing all AVIC non-running vCPU wakeups on that
IOMMU.

Clear only the bits actually observed this round by writing status & mask
instead of mask. An overflow bit set concurrently is then left asserted
and is picked up by the existing ERBT1312 status read-back at the bottom
of the loop, which re-enters the loop and runs overflow_handler().

Fixes: 2379f3485239 ("iommu/amd: Refactor IOMMU interrupt handling logic for Event, PPR, and GA logs")
Signed-off-by: Guanghui Feng <guanghuifeng@xxxxxxxxxxxxxxxxx>
---
drivers/iommu/amd/iommu.c | 13 +++++++++++--
1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/iommu/amd/iommu.c b/drivers/iommu/amd/iommu.c
index d0d55c93a480..39254671b924 100644
--- a/drivers/iommu/amd/iommu.c
+++ b/drivers/iommu/amd/iommu.c
@@ -1168,8 +1168,17 @@ static void amd_iommu_handle_irq(void *data, const char *evt_type,
u32 mask = int_mask | overflow_mask;

while (status & mask) {
- /* Enable interrupt sources again */
- writel(mask, iommu->mmio_base + MMIO_STATUS_OFFSET);
+ /*
+ * Clear only the status bits observed in this round. The log
+ * overflow bits (GALOverflow/EventOverflow/PprOverflow) are RW1C
+ * and do not raise an interrupt on their own; clearing them
+ * unconditionally here would drop an overflow that hardware set
+ * between the readl() above and this write, without ever running
+ * overflow_handler(). Leaving such a bit asserted lets the
+ * existing ERBT1312 read-back below re-observe it and re-enter
+ * the loop so overflow_handler() runs.
+ */
+ writel(status & mask, iommu->mmio_base + MMIO_STATUS_OFFSET);

if (int_handler) {
pr_devel("Processing IOMMU (ivhd%d) %s Log\n",
--
2.43.7