Re: [PATCH 0/2] arm64: dts: allwinner: h6: Enable Ethernet on Tanix TX6
From: Jun Yan
Date: Mon Nov 16 2026 - 09:25:17 EST
Hi Jernej,
> The AC200 MFD and Ethernet PHY drivers and their bindings were merged
> in v7.4-rc1. This series adds the device tree parts needed to use them
> on H6, starting with the Tanix TX6 and TX6 mini TV boxes, whose only
> Ethernet port goes through the PHY in the AC200 co-packaged with the
> H6.
>
> Patch 1 describes the AC200 in the H6 dtsi: the I2C3 controller with
> the AC200 on it, a pwm-clock that provides its 24 MHz reference clock
> from PWM1, the RMII pins and the EPHY calibration value in the SID.
> Everything stays disabled.
>
> Patch 2 enables Ethernet on the Tanix boards.
>
> Tested on a Tanix TX6: 100 Mbit/s full duplex, about 11 MB/s in each
> direction, and the link comes up both after cold boots with no
> Ethernet initialisation in U-Boot and after U-Boot has used it. The
> TX6 mini shares the same dtsi and was not tested separately.
>
> The arm64 defconfig does not enable CONFIG_MFD_AC200 and
> CONFIG_XPOWERS_ACX00_PHY yet; I can send a separate patch for that.
>
> Best regards,
> Jernej
>
> Jernej Skrabec (2):
> arm64: dts: allwinner: sun50i-h6: Add AC200 companion chip
> arm64: dts: allwinner: tanix: Enable Ethernet
>
> .../boot/dts/allwinner/sun50i-h6-tanix.dtsi | 40 ++++++++++++++
> arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi | 53 +++++++++++++++++++
> 2 files changed, 93 insertions(+)
>
> --
> 2.43.0
Same AC200 setup on TaiqiCat (TQC) A01; I'll send the board enablement
separately once the H6 dtsi changes are merged.
Thanks,
Jun