[PATCH 2/2] ALSA: usb-audio: Add quirk flags for Logitech PRO X 2 LIGHTSPEED
From: chris
Date: Fri Nov 20 2026 - 07:05:07 EST
The receiver of the Logitech PRO X 2 LIGHTSPEED headset (046d:0af7)
resets itself on ordinary requests such as SET_INTERFACE when it has
been hotplugged and not yet gone through a reset of its own. When the
probe-time interface setup runs shortly after configuration, the
receiver can instead stop answering control requests altogether until
its watchdog resets it about 77 seconds later, and the headset may not
pair afterwards.
Skip the probe-time interface setup, so that the first alt setting
change happens at stream open. The receiver still resets once there,
but re-enumerates within half a second and then works normally. Also
set IFACE_DELAY: the delay after SET_INTERFACE lets the receiver drop
off before the sample rate request is sent; otherwise that request is
in flight when the device disappears and the disconnect waits for the
control message timeout, delaying recovery by five seconds.
Keep CTL_MSG_DELAY_1M from the Logitech vendor entry, which a device
entry replaces.
A receiver that is present at boot is not affected.
Assisted-by: AI
Signed-off-by: Christopher Snowhill <chris@xxxxxxxxxx>
---
sound/usb/quirks.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/sound/usb/quirks.c b/sound/usb/quirks.c
index cff10fac496f..29523d2a99bd 100644
--- a/sound/usb/quirks.c
+++ b/sound/usb/quirks.c
@@ -2284,6 +2284,9 @@ static const struct usb_audio_quirk_flags_table quirk_flags_table[] = {
DEVICE_FLG(0x046d, 0x0aba, /* Logitech PRO X Wireless */
QUIRK_FLAG_MIXER_GET_CUR_OK |
QUIRK_FLAG_MIXER_PLAYBACK_MIN_MUTE),
+ DEVICE_FLG(0x046d, 0x0af7, /* Logitech PRO X 2 LIGHTSPEED */
+ QUIRK_FLAG_CTL_MSG_DELAY_1M | QUIRK_FLAG_SKIP_IFACE_SETUP |
+ QUIRK_FLAG_IFACE_DELAY),
DEVICE_FLG(0x0499, 0x1506, /* Yamaha THR5 */
QUIRK_FLAG_GENERIC_IMPLICIT_FB),
DEVICE_FLG(0x0499, 0x1509, /* Steinberg UR22 */
--
2.56.0