Re: [PATCH net-next] net: mdio: handle broken-turn-around for non-PHY MDIO devices

From: Bastian Germann

Date: Fri Nov 20 2026 - 17:44:41 EST


On 11/20/26 23:07, Andrew Lunn wrote:
On Fri, Nov 20, 2026 at 10:40:55PM +0100, Bastian Germann wrote:
On 11/20/26 01:33, Andrew Lunn wrote:
On Fri, Nov 20, 2026 at 12:13:19AM +0100, Bastian Germann wrote:
The "broken-turn-around" property is documented in mdio.yaml for any
MDIO device, but the MDIO core currently parses it only for PHY devices
in fwnode_mdiobus_phy_device_register(). Non-PHY devices, such as DSA
switches, are registered through of_mdiobus_register_device(), where the
property is ignored, so MDIO bus drivers that rely on phy_ignore_ta_mask
still treat the turn-around/read failure as an error.

Parse the property when registering a non-PHY MDIO device and set the
corresponding bit in phy_ignore_ta_mask before registering the device.
What switch is causing you problems?
It is with mv88e6085.

I have just found that Nathan Rossi sent basically the same patch as
<20210217044443.1246392-1-nathan@xxxxxxxxxxxxxxx>.
[Goes and find the thread]

Are you bit banging as well? Or do you have another MDIO bus
controller?

The point about the mv88e6085 using multiple addresses is valid. How
do you have the mv88e6085 configured?

It is with the TI CPSW3G MDIO controller (ti,davinci_mdio, ti,cpsw-mdio).
As this is on a AM64x, errata i2329 applies and davinci_mdio runs with bitbanging.

The mv88e6085 (88E6341) is configured in multi-chip/indirect mode at  reg = <1>.
It does not use multiple addresses.